-Conforms to U.S. Dept. of Labor, OSHA Standard 1910.242 (B) allowing a maximum of 30 PSI outlet pressure at the nozzle when dead-ended.
-Conforms to U.S. Dept. of Labor, OSHA Standard 1910.95 regulating noise level exposure.
-Conforms to Title 41, Walsh-Healy Rules and Regulations P50-204.8 Safety and Health Standards.
-Slender 4" extended nozzle allows access to hard to reach places and holes as small as .200".
-Pressure rating - 150 PSI
-Variable output trigger enables user to control air flow.
-Hook design near trigger provides finger protection as well as easy storage.
-Lightweight to help minimize user fatigue.
-Side holes allow air to escape if nozzle tip is dead-ended, thus preventing back pressure buildup.

-Quick Connect: Simply push tubing in. No tools required. Saves up to 75% of assembly time of standard compression fittings.
-Quick Disconnect: Hold two fingers on insert and pull tubing out. No tools required.
-Reusable: Connect and disconnect numerous times.
-Full Flow Design: Provides up to 60% more flow than conventional fittings with internal tube supports.
-Positive Seal: No leaks. After tubing is inserted, seal is made.
-Secure Tube Retention: Pulling on tubing only serves to tighten the connection.
-Brass Construction: Elbows and tees are Forged Brass.
-Pre-applied Teflon based pipe sealant on all male pipe threads, saving customer additional labor.
-Working Pressure: Fittings are suitable for use up to the maximum working pressure of the plastic tubing used. Also suitable for vacuum service.
-Working Temperature: -10*F to 200*F

Bendable Blow Guns

-Quick action - no levers or triggers.
-Slight flex of hose in any direction releases air discharge from controlled flow to full blast.
-Lightweight, self-cleaning and corrosion resistant.
-Complies with OSHA 1910.95 and 1910.242(b).